Perle S-1110P-S1SC20D - Fiber media converter - GigE - 10Base-T, 100Base-TX, 1000Base-T, 1000Base-BX - SC single-mode / RJ-45 - up to 12.4 miles - 1490 (TX) / 1310 (RX) nm

Smart link pass-through. When the link mode switch is placed into smart link pass-through mode, the copper Ethernet port will reflect the state of the 1000Base-X media converter port. This feature can be used whether fiber auto-negotiation is enabled or disabled. Auto-MDIX. Auto-MDIX detects the signaling on the copper Ethernet interface to determine the type of cable connected and automatically configures the connection when enabled. The media converter can also correct for wires swapped within a pair. Fiber redundancy. When enabled on dual fiber models, the media converter treats fiber 1 as the primary and if the link fails, the fiber link is switched over to fiber 2. Pause (IEEE 802.3xy). Pause signaling is an IEEE feature that temporarily suspends data transmission between two devices in the event that one of the devices becomes overwhelmed. The media converter supports pause negotiation on the 10/100/1000Base-T connection and 1000Base-X fiber connection. SFP speed sensing. It can automatically detect whether a gigabit or Fast Ethernet fiber SFP has been inserted and adjusts accordingly. PD power reset. It is ideal for remotely resetting equipment, this configurable function performs a momentary power reset to the attached Powered Device (PD). When enabled, the media converter will, upon loss of fiber RX, turn off PSE output power supplied to the PD device for 2 seconds then turn the power back on and leave it on until such time that another fiber RX link is lost. When disabled, a loss of fiber RX has no effect on PSE power to the PD device. Auto-negotiation (802.3u). The media converter supports auto negotiation. The 1000Base-X fiber interface negotiates according to 802.3 clause 37. The 10/100/1000Base-T negotiates according to 802.3 clause 28 and 40. The 1000Base-X will link up with its partner after the highest common denominator (HCD) is reached and the copper has linked up with its partner. Fiber fault alert. With fiber fault alert the state of the 1000Base-X receiver is passed to the 1000Base-X transmitter. This provides fault notification to the partner device attached to the 1000Base-X interface of the media converter. If the 1000Base-X transmitter is off as a result of this fault it will be turned on periodically to allow the condition to clear should the partner device on the 1000Base-X be using a similar technique. This eliminates the possibility of lockouts that occur with some media converters. Power strain relief strap. A strain relief strap is provided to ensure a solid and secure power connection to the media converter. It is ideal for areas that may be exposed to vibration.